ONKYO TA-RW255 Manuale Utente Pagina 6

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
Vedere la pagina 5
6
To play a tape
Check once again that all connections have been completed exactly as indicated in the connections diagram and then plug in the AC
power cord.
After turning the power on, the display illuminates and the
g
PAUSE indicator flashes (about 5 seconds). While the indicator is flashing,
no operation can be performed.
This deck holds two cassettes at once. Both Deck A and Deck B are capable of auto-reverse playback; Deck B can also record.
•Tapes can be played back using either Deck A or Deck B. Follow the procedure on Deck A or B. (Deck A is pictured.)
ONKYO
1234
5
3
1
4
5
2
ONKYO
EJECT
REVERSE MODE
DOLBY NR
1. Press the EJECT button to open the
cassette holder.
2. Insert a cassette.
The side of the cassette with the exposed
tape should be facing downward.
3. Set the Dolby NR by pressing the
DOLBY NR button repeatedly until
the proper Dolby NR indicator
(OFF, B or C) turns on.
Select the same noise reduction system
that was used when the cassette was
recorded. For instance, tapes recorded
using Dolby B NR should be played
back with Dolby B NR.
4. Set the Reverse Mode by pressing the
REVERSE MODE button repeatedly
until the desired mode is displayed.
( v ) one side: Only one side of the
tape is played back.
( b ) repeat: Both sides of the tape
are played back repeatedly eight times
or until the e button is pressed.
5. Start playback.
Press the a or s button depending
on which side of the cassette you wish
to listen to.
s : Playback starts from the front
side.
a : Playback starts from the reverse
side.
The auto-stop mechanism will auto-
matically stop the tape (depending on
the tape transport mode) if a tape is
played through to the end.
Press the e button.
Listening to a tape
Stopping playback
TA-RW255_En.book Page 6 Tuesday, April 19, 2005 4:36 PM
Vedere la pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commenti su questo manuale

Nessun commento